Automatic Technology Australia Elite Instrukcje Operacyjne Pobierz pdf (Strona 18)

FAULTS AND REMEDIES

SPECIFICATIONS

DIVE UNIT

Motor: 24 volts DC

Speed: Drive arm/motor speed is adjustable in the control box

Size: 135mm wide, 290mm high and 230mm deep

Weight: 13kgs including arms

ELECTRONIC CONTROL BOX

Input Voltage: 240 volts/50Hz AC

Output Voltage: 24 volts DC from control board

Transformer Rating 24 volts AC, 100VA

Control System Microprocessor control unit

Surface mount technology circuit board

Wiring System Via on board terminal blocks

External Box Weatherproof box when used with mounting kit and cable gland, IP56 rated

Transmitter/Receiver ATA model hand held transmitter 4 buttons, code hopping type, 9 VDC batteries included

ATA model receiver two channel code hopping type with over 4.29 billion codes

and 27 transmitter code store capacity. The transmitter frequency is 433.92 MHz.

Size 190mm wide, 240mm high and 100mm deep

Weight 4Kgs

The specifications above are approximate only.

ATA reserve the right to alter specifications at any time without notice in accordance with the Company’s policy of continuous product development.

Page 18

Remote transmitter not functioning New transmitters must be coded to the receiver (refer to page 16).

Check/change the battery in the transmitter.

Having the antenna behind a structure (gate or fence) or out of sight may

reduce optimal range/reception.

Interference from external/outside sources such as baby monitors, or radio

transmitter etc. The best solution is to remove the source causing the in-

terference.

Gate re-opens when closing or stops when opening Check obstruction overload sensitivity adjustment (See Page 12, step 7)

Check for obstructions.

Disengage the drive unit to manual (see page 7) and check the gate is in

good working order (see page 6 step 1.1 & 1.2).

If a P.E. beam is fitted ensure it is clear of obstructions or dirt on the lense

Gate does not open and/or close Check that Control Box is plugged into mains power.

Check that motor is engaged for automatic operation.

Check all wiring from motor and microswitches to the control board are

sound.

Gate or opener requires a service Contact the installer of the opener or local ATA distributor for service.

They will be able to inspect, reset, service, adjust or repair the gate and

opener as necessary.

1 2 ... 13 14 15 16 17 18 19 20

Brak uwag

Automatic Technology Australia Elite Instrukcje Operacyjne Strona 18