Automatic Technology Australia Elite Instrukcja Instalacji Pobierz pdf (Strona 4)

IMPORTANT SAFETY INSTRUCTIONS

For ADDITIONAL SAFETY protection we

STRONGLY recommend the fitting of a Photo Electric

Beam. In most countries Photo Electric Beams are

mandatory on all gates fitted with automatic openers.

For a small additional outlay ATA recommends that

Photo Electric Beams be installed with the

automatic opener ensuring additional safety and peace

of mind.

DO NOT operate the gate opener unless the gate is in

full view and free from objects such as cars and

children/people. Make sure that the gate has finished

moving before entering or leaving the driveway.

DO NOT operate the gate opener when

children/persons are near the gate. Children must be

supervised near the gate at all times when the gate

opener is in use. SERIOUS PERSONAL INJURY

and/or property damage can result from failure to follow

this warning.

DO NOT allow children to operate the gate opener.

Keep the remote control away from children. SERIOUS

PERSONAL INJURY OR DAMAGE can result from

failure to follow the instructions.

Make sure that the SAFETY OBSTRUCTION

DETECTION system is working correctly, and is

TESTED every month. Test as per the Installation

Instruction Manual. Adjust if necessary and recheck.

Failure to follow this rule could result in SERIOUS

PERSONAL INJURY and/or property damage.

DO NOT disengage the gate opener to manual operation

with children/persons or any other objects including

motor vehicle within the gateway.

If using a key switch or keypad or any device that can

operate the gate opener, make sure it is out of reach of

children and that the gateway is in full view at all times.

If the power supply cord is damaged, it MUST be

replaced by an ATA service agent or suitably qualified

person.

Make sure that remote controls are kept out of reach of

children.

Warning - It is vital for the safety of persons to follow all instructions. Failure to comply

with the following Safety Rules may result in serious personal injury and/or property damage.

The opener is showerproof - it should not be immersed

in water or sprayed directly by a hose or other water

carrying device.

The gate(s) must be WELL BALANCED. and in good

working order. Faulty gates must be repaired by a

qualified technician prior to opener installation.

REMOVE OR DISENGAGE all gate locks and

mechanisms prior to installation of the opener.

Connect the gate opener to a properly EARTHED

general purpose 240V mains power outlet installed by a

qualified electrical contractor.

DISCONNECT THE POWER CORD from mains

power before making any repairs or removing covers.

Only EXPERIENCED service personnel should

remove covers from the gate opener.

Keep hands and loose clothing CLEAR of the gate and

opener at all times.

When using auto close mode a PHOTO ELECTRIC

BEAM must be fitted correctly and tested for operation

at regular intervals. EXTREME CAUTION is

recommended when using auto close mode. ALL

SAFETY RULES above must be followed.

In order for the gate opener to SENSE an object

obstructing the gateway, some FORCE must be

exerted on the object. As a result the object, gate and/or

person may suffer DAMAGE or INJURY.

Make sure that the gate is fully open before driving into

or out of the driveway. And make sure the gate is fully

closed before leaving the driveway.

The gate opener is not intended for use by young

children or infirm persons without adequate supervision.

Children should be supervised to ensure that they do not

play with the remote transmitters or the opener.

Frequently examine the installation, in particular hinges

and mountings for signs of wear, damage or imbalance.

DO NOT use if repair or adjustment is needed since a

fault in the installation or an incorrectly balanced gate

may cause injury.

PLEASE READ THIS INSTRUCTION MANUAL FULLY BEFORE ATTEMPTING TO INSTALL

OR USE THE OPENER. FAILURE TO COMPLY WITH THE INSTALLATION INSTRUCTIONS

MAY RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE.

1 2 3 4 5 6 7 8 9 ... 23 24

Komentarze do niniejszej Instrukcji

Brak uwag

Automatic Technology Australia Elite Instrukcja Instalacji Strona 4

Komentarze do niniejszej Instrukcji