Automatic Technology Australia Elite Instrukcja Instalacji Pobierz pdf (Strona 7)

DRIVE UNIT INSTALLATION

The ATA Elite swing gate opener is designed to operate most

residential swing gates. The gates must be in good working

condition and should operate by hand relatively freely. Wind

loading may affect the operation of the opener in high wind areas.

Correct obstruction and reversing settings should be chosen for

trouble free operation.

PRE-INSTALLATION INSPECTION

Before commencing installation check the following:

1. The gate moves freely by hand for it’s full opening and

closing travel.

2. The pier or post for mounting must be of solid construction

(Brick, solid timber or steel). It must bare most of the force

applied by the drive unit.

3. A weatherproof 240V 10A general purpose power point

should be available within one metre of the pier/post.

4. If dual gate openers are required, provision for underground

cabling should be made from one post to the other.

5. Side room clearance is adequate. Refer to Table 1 and Fig. 2.

If there is not enough side room available, the Minimum Side

Room Kit (Page 9) is required.

6. The mount distance of the Drive Unit should be recorded. This

value will be used later.

FIG. 2

MOUNT

DISTANCE

HINGE DISTANCE

0 50 100 125 150 180 200 220

SIDE ROOM CLEARANCE

90 470 470 470 470 470 470 465 460

120 450 470 480 470 465 460 435 425

140 470 465 470 465 460 440 420 390

200 470 465 445 430 400 350 390 250

The mount distance for the drive unit and the hinge distance for the

gate can be selected to optimise the side room clearance.

NOTE: If the gate is already installed then measure the hinge

distance and use this table to optimise the mount distance.

All dimensions are in mm

TABLE 1

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Brak uwag

Automatic Technology Australia Elite Instrukcja Instalacji Strona 7